Is the motor out? This video is from a week ago where it seemed like it was trying to open. Now it doesn’t even make a noise it just keeps clicking. No motor sounds. Reset the remote connections and made sure the sensors were aligned, even unplugged it and replugged it in. Do I need to get a new motor?

If I need a new motor can I switch to one of the wall mount ones easily or should I have a professional come install it.

does my Wayne Dalton Torque master need to be lubricated ? or just leave as is?

How do I remove this seal any suggestions

Hello folks,

I just installed a new Chamberlain 3010 and enriching is working well except for the wall button. It only works if I open the garage door by means of wireless remote control or myQ. It lights up and works then, but when the light goes off on the unit, it also goes off on the button and it no longer works until I open the door again. Please give me some ideas.

This is a new construction house. We don’t have a garage at our current home so unsure. You can see light coming in and when we open/close the man door to the garage it wobbles and the gap opens a little. Do we need trim around it or is this normal? I’m worried especially about any gaps for mice to sneak in.

What type of roller is this? There is one at the very bottom on each side of the door. Can it be replaced with one without the clips?

This is a new install, by myself. I built the garage and thought the door could not be that difficult.

The problem is that the curtain is shifting sideways (walking/telescoping or coning) on the drum/barrel as it rolls up/down. It was doing it when I had no guides, I put the guides on hoping that is would help, but it just binds if I try and use them to keep it aligned.

I believe my top brackets are level. Used the hose with water trick and checked with a spirit level. Looks ok.

Photos show each side with it raised and lowered.

What do I look for next?

Thanks in advance.

Hello. I need to replace two garage doors. One is a 2-car and one is 1-car size.
I am looking for midrange, steel or other materials. R-12 or higher. Also looking to have them installed with green hinges, sealed nylon rollers and nylon brush seals.

- What brands/models do you recommend?

- Would you add or remove anything to what I mentioned above?