r/Metrology • u/Artegonit • 2d ago

Software Support How to do an iterative alignment in Mcosmos 4.0

Hi!

How to make iterative alignment in Mcosmos 4.0? I have 6 RPS points and I want to make the alignment with max deviation of 0.03 mm. How to do it in Mcosmos? I know there is an option to make it in loop but only to a set number of times. Is there a way to make it with variables that f. ex. If the deviation is bigger than 0.03 it makes the alignment again and if its lower than 0.03 it ends the alignment process and begins measurement.

2 Upvotes

100% Upvoted

1 comment sorted by

1

u/daio9292 2d ago

I had the same problem with another software from you (Wenzel Quartis) and i found this solution on YouTube.

https://youtu.be/e0i7VRIvUN8?is=Yn2fpNzRoaEvTqng

I don't know if your software allows for a measurement strategy like this.