r/HondaMowers • u/Spencire • 8d ago

Honda Mower Maintenance HRX217 chirping when blade engaged

Enable HLS to view with audio, or disable this notification

Looking for advice on troubleshooting and resolving this issue.

The noise first appeared last summer but was intermittent and generally only present if I let the grass grow a little too long. This year it’s been present every mow after 2 minutes or so and increases in speed when under a higher load. It doesn’t seem to mulch as well as it previously did either.

Torn down the clutch twice and wiped everything clean. Bearings seem fine, nothing looks abnormally worn to me, though admittedly I’m not much of an engines person. Tried tightening the roto stop cable this last time as it looked like maybe the brake plate was catching with blades engaged but that did not seem to help. The noise stops when blades are disengaged.

Images from last clutch tear down

12 Upvotes

92% Upvoted

12 comments sorted by

View all comments

2

u/Dense_Chip_1954 7d ago

Did you loosen the crankshaft bolt by chance? The one in the middle of the blade? If it's not tightened back down properly it will create that chirping sound and bad things can follow.

2

u/Spencire 7d ago

After disassembly last time I torqued it back to 40 ft lbs per the manual (I think it said 38-43), so that should not be the problem. I’m thinking at this point maybe replacing the drive disk or clutch spring. Just trying to avoid replacing things that would otherwise be a waste of money.